I'm still working on shop projects, as well as gifts and retail products. Busy, busy. Wanting to get back to work on my plan for a tall hand tool cabinet, I was not keen on spending a lot of time fabricating a longer lathe stand for last winter's purchase of a bed extension for my Jet Mini lathe.
I'd purchased wide lumber, 20" maple at 8/4 thick. I wanted an S-curve, girdled looking leg on the outsides, but my bandsaw only has a 16" throat, so-o-o I was going to have to split the 20" width, resaw it and cut the arcs, then joint and dowel the two pieces back together. The idea put me off a bit. I had drawn up a fine design, but could foresee two weeks working with it to accomplish what I needed.
Along the way I discovered buyer's reviews of the metal-legged Penn State Industries lathe stand. It is the only one I've found that is adjustable in length. Previous buyers' main complaint seemed to be that the directions were incomprehensible....big surprise. They said it is 'rock steady once assembled,' and 'just be sure to align all the square holes on the outside, round holes on the inside,' and it's easy-peasy. With that guidance, my new lathe stand was assembled in one afternoon. Sixty square carriage bolts later, with wood added, I had a very nice, solid stand for the extension bed, much more room to lay down the gouges I'm currently working with, and storage underneath. It's a Win Win!
Here are two pics, one of the the Jet Mini as it is now, and one of the right side of my garage, with the Woodfast Short Bed bowl lathe on the right, the Jet mini on the left, and the grinder within easy reach of both. Now to find some showy woods for Long French Rolling Pins, comin' up!